Garage door won't close: sensor repair in Wayne

A door that starts down and comes straight back up is nearly always telling you about its safety sensors.

Call (862) 429-4107

In short

Blinking sensor light, door reversing, or a door that only closes while you hold the wall button: all three point to the photo-eye sensors. Clean and realign them first. If that doesn't work, call, and a technician in Wayne repairs the sensors and re-tests the opener's safety system.

Wi-Fi garage door opener mounted on the ceiling

Doors that won't close in Wayne

Around Packanack Lake, Pines Lake and Lionshead Lake, garages sit close to the water and stay damp, and the lake communities' older garages were not built with openers in mind. Corrosion on sensor wiring is common there. Along the Pompton and Passaic rivers, some garages have been through flood water. Sensors that have been submerged may work for months and then fail, and they should be replaced as a pair rather than cleaned. In Preakness, the usual cause is a bumped bracket.

What it means when the door won't go down

Every opener made since 1993 has two photo-eyes a few inches above the floor, one on each side of the door. If the beam between them is broken, or the opener cannot tell whether it is, the door will not close from the remote.

  • Blinking sensor light: the eyes are out of line or one lens is dirty.
  • Both lights off: no power to the sensors, usually a wire pulled loose or chewed.
  • Lights steady but the door still reverses: the problem is the close limit, the force setting, or something binding in the track.

Quick things to rule out

  • Is anything in the path of the beam, even a leaf or a cobweb?
  • Are both sensor lights lit and steady?
  • Does the problem only happen at one time of day? That points to sun in the sensor.
  • Is the wall control's lock or vacation button switched on? It disables the remotes.

Anything beyond that, including limit and force adjustment, is a job for a technician, because a wrong setting can stop the door from reversing when it should.

How the repair is done

The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.

Around Wayne

  • Preakness: Central Wayne around Valley Road, with split-levels and bi-levels.
  • Mountain View: Older section near the rail station and Route 23.

See the full Wayne service area.

Door stuck? Call before you try to force it.

A door with a broken spring or cable can drop suddenly. Leave it closed, keep clear, and call. We'll tell you whether it's safe to use and get a technician scheduled.

Call (862) 429-4107
Call (862) 429-4107